As stated in my Unveiled! Post, I will post at least twice per week about a new Autodesk Inventor 2013 feature until I’ve run through the entire list. When I run out of new features, I’ll start going through the veteran features until the next version of Inventor is released.
This will create a handy way to easily find out what specific features do, and allow for commentary on the plusses and minuses of each feature, and allow for people to describe their own workflows for the feature in question. At the very least, it will be very helpful to the struggling noob
As each feature post is published, it is automatically added to the list is over to the right. Enjoy.
I’ve tried a couple times to add a forum to this blog, but they were always on the buggy side, or would blow the site’s formatting up. But I think I have finally found one that will do the trick. It is located at the link above, and should be used for anything that doesn’t fit in the comment section below every post.
Let me know in the General > Whatever section what groups and (like General) and Forums (like Whatever) you would like, and I’ll add them ASAP. I will be adding some of my own accord as well so hopefully we’ll wind up with a well rounded list. We are also looking for moderators who can spend a little time daily doing moderator stuff. If you have posted in the comments before today and wish to take on the task, just send me an email and let me know you’re interested.
There will be a very interesting post early tomorrow about Inventor 2013 so stay tuned…