An Introduction to Autodesk Inventor iLogic
Testing the iLogic Rukes for Ranges of Values

What about cases where mass is not limited to the exact values but may occur in several ranges of values? The following example will illustrate this case.

Let’s modify an existing rule. Open the iLogic Tree Editor, and double-click on Width_Rule to open it in the Rule Editor.

Modify the rule as follows:

Here, we are checking for a range of values in each of the If statements. Click OK to close the Rule Editor.

Autodesk's Introduction Tutorial for iLogic Adding the iLogic Parameters Opening the iLogic Parameter Editor Create a 'Holes" Parameter String Create a 'Holes" Parameter String - Continued Using Parameter Filters Creating iLogic Rules Creating iLogic Rules - Continued Creating iLogic Rules - Continued Creating iLogic Rules - Continued Creating iLogic Rules - Continued Testing the iLogic Rules Renaming the iLogic Rule Test the iLogic Chamfer Rule Rule #3 - Bracket Dimensions Rule #3 - Bracket Dimensions - Continued Testing the iLogic Width Rule Testing the iLogic Rukes for Ranges of Values Remove the Multi-Value List for the Mass parameter Remove the Multi-Value List for the Mass parameter - Summary