An Introduction to Autodesk Inventor iLogic
Testing the iLogic Width RuleiLogic Parameter Editor Icon

To test this rule, open the iLogic Parameter Editor. 

First, set the value of the mass parameter to 100. The bracket width is set to 1 inch.

Creating a "Mass" parameter in the iLogic Parameter Editor

Change the mass parameter value to 200 and notice that the bracket width changes again...

Testing the new iLogic parameters.

Changing the mass to 300 causes the width of the bracket to increase to 3 inches. A mass of 400 results in a 4 inch wide bracket. Try it...